JetStream Software Portal

Re-protecting a VM Previously Protected by JetStream DR

Issue

When a VM protected by JetStream DR is recovered from backup software or is cloned, it will still retain the JetStream DR storage policy. The persistence of the old JetStream DR storage policy will prevent the recovered VM from being able to be re-protected with JetStream DR.

Attempting to protect a VM under this condition will fail and an error related to the VM storage policy will be indicated.

VM storage policy error message.

Solution

  1. It is crucial that any VM being set up for protection by JetStream DR does not retain any JetStream storage policy associated with its VM disk(s).

  2. Validate storage policies:
  • Go to Edit settings of the VM and check the Hard disk VM storage policy for any reference to a “JetDR” policy.
Check the hard disk storage policy.
  • Select the VM then navigate to Policies under the Configure tab and check for any reference to a “JetDR” policy.
Check the VM storage policy.
  1. If any JetDR policies are discovered in either location, change the disk storage policy to a non-JetStream policy or the datastore default value.

  2. After all JetDR policies have been removed, attempt the JetStream DR protection process again.

In rare cases, if a VM is intentionally unprotected for maintenance purposes, the JetDR VM storage policy attached to the disk may not be automatically cleaned up.
If this situation is encountered, follow the same steps described above then re-protect the VM.

Was this article helpful?

Related Articles

Can We Help You?

Can't find what you're looking for?
Contact JetStream